Our (MM-BSM-7) is hand-made with high quality products to ensure long life and excellent recordings! These omni- directional microphones are smaller than an eraser head of a pencil. Each microphone element (panasonic 61 series) is mounted into there own durable brass capsules ( approx. 1/4" in diameter x 1/2" long). Six feet of high quality shielded microphone cable exits the rear of each capsule and are terminated into a gold plated 1/8" ( 3.5 mm) stereo plug. Microphones come standard with 360 degree (rotational and removable) holding clips and premium wind screens!

These microphones have a very naturally crisp sound, providing deep bass, smooth mid-range and clean high-range with a frequency response of typically +/-2dB. They can be easily plugged into any Minidisc, Dat or analog recorder that supplies a bias voltage of between 1.5 to 10 volts D.C. (also known as plug in power) at the microphone input jack.

Note: If your recorder does not provide a bias voltage or if you want to feed your recorders line inputs to avoid overloading your recorder's mic pre-amplifier, you can use one of our Battery Modules (check out our Battery-Module Section).

Battery Modules will power the microphones with optimum power ( 9 volts D.C ), increase dynamic range and enable the mics to handle higher (SPL) sound pressure levels ( loud sounds ) without distortion.

• Frequency response: 20- 20,000 Hz
• Signal to noise ratio: 62dB, 1khz at 1pa
• Open circuit sensitivity : -35dB (5.6 mv) re 1v at 1pa
• Dynamic range: 95dB, 1kHz
• Maximum Input Sound Level: 105dB SPL (120 db when used with one of our battery modules), 1kHz at 1%

• Flat frequency response
• Comes with holding clips and premium windscreens.
• Requires a bias voltage of 1.5 to 10 volts D.C. (also known as plug-in- power) or one of our battery modules.
• Includes Life- Time Warranty at no extra charge!

• Check out our Battery / Filter Module Section (mono) or (stereo)